Bullet-tools Magnum Rigid Foam Cutter Manuel d'utilisateur télécharger pdf

Set Up:

1) Recommended stand: Two (2) four ft (or longer) sawhorses

with two 46” to 47” long 2X4’s attached as shown.

Alternatives:

   •Clamptotabletopwith8”Cclamp.

   •Screworbolttoworkbench.

 Bestset4”to6”belowwaistheight

2) SecurelymountCutterbasetopreferredstand.

Fastenwithscrewsorclamps.

3) Removethe1/2”bolts

  fromthesidesupports

4) Unfoldoneofthesidesupports

  andlockinplacewithlockingpin

5) Slidethehorizontalbar

  throughtheuprightsidesupport

at least 6”

6) Slidethebladecarriageassembly

  ontothehorizontalbar

  Leaveatleast2”exposedontheunsupportedend.

7) Unfoldtheothersidesupport

  andlockintoplace

8) Slidethehorizontalbar

  intothesidesupport

9) Re-insert1/2”bolts

  intobothsupportsandtightenlocknuts

MagnUM Rigid FoaM CUtteR

Set-up&OperationInstructions

20/”

47”

CAUTION:SHARPBLADE!

1 2 3

Résumé du contenu

Page 1 - MagnUM Rigid FoaM CUtteR

Set Up:1) Recommended stand: Two (2) four ft (or longer) sawhorses with two 46” to 47” long 2X4’s attached as shown. Alternatives:   •Clamp

Page 2 - MaintenanCe:

Forproductsthickerthan1”,Lowerbladeto1/2ofproductthickness.1” OR LESSOVER 1”1” OR LESSOVER 1”Forproducts1”orthinner,Lowerbladeto1/4”b

Page 3 - ShaRp blade

SaFety1) ShaRp blade -Thismachineusesarazorsharpblade.Keephands,feet,andotherappendagesawayatalltimes.2) WearKevlar™orcut-resista

Commentaires sur ces manuels

Pas de commentaire

Bullet-tools Magnum Rigid Foam Cutter Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Outils Bullet-tools Magnum Rigid Foam Cutter. Bullet Tools Magnum Rigid Foam Cutter User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Bullet-tools Magnum Rigid Foam Cutter